Install a kitchen sink mixer with a pull-out mixer spout

Follow this installation guide steps by steps or play the video to watch the installation.

Preparation

1 - If major work is done on the home, the water network must be flushed of all impurities to avoid damaging your mixer.

2 - Before dismantling your old unit identify the hot and cold water feeds, then shut off the water supplies.

3 - Prepare parts and tools with close access to the connections.

Installing the upper part of the mixer

1 - Pick up the mixer and water-tight seal. Place the water-tight seal over the two hoses.

GROHE Magazine

2 - Position the water-tight so that it sits securely on the base of the tap and hold it there.

3 - Insert the hoses through the hole in the sink for the mixer.

4 - Place the mixer so that the water-tight seal is in contact with the sink, . Hold the mixer in this position.

5 - Insert the flex hose into the upper part of the high spout.

6 - Then fit the entire spout on to the mixer body.

7 - Use the hoses to hold the mixer firmly until it is attached.

Installing the lower part of the mixer

1 - Place the stabilization ring over the hoses, and then along the threaded rod. Similarly, place the tightening seal and then, lastly, place the tightening nut. Hand-tighten the nut to the maximum.

2 - Release the mixer, which is now held in place, and visually check the mixer's orientation. Adjust it if necessary.

3 - Hold the mixer and use a 17 mm open-end wrench to tighten the nut without forcing.

4 - Under the sink, place one side of the figure-8 shaped ring over the spray hose.

5 - Slide the spring onto the spray hose making sure that the black plastic ends are still in place of the spring

6 - Slide the end of the spray hose through the second figure-8 shaped ring.

7 - Hold the spring and the ring, then screw the hose into the end of the push fit connector.

8 - Slide the push fit connector and lock it into place on the brass rod. Verify that the push connector is correctly fitted by pulling on it.

Turning on water

1 - Make sure that the seal is present in the hoses. If necessary, add a fiber or rubber seal. Screw the left-hand hose onto the hot water faucet, and the right-hand hose on the cold water faucet. Tighten with a 19 mm open-end wrench. Make sure there are no kinks or bends in the hoses.

2 - Make sure that movement of the flex hose for the pull-out spout is not obstructed by any obstacles. Open the two water lines and make sure the faucets do not leak.

3 - Make sure the mixer is operating properly.

Congratulations, you have finished installing your new GROHE product. Check our other installation guides and discover all of our products on grohe.com/uk

We use cookies to ensure that we give you the best user experience on our website. If you continue your visit, we’ll assume that you are happy to receive all cookies. Find more detailed information about how cookies are used on this website on our Privacy Disclaimer